Olivetti Fax-Lab 115, Инструкция по эксплуатации

Страница: 51 / 64

4 9
M
AINTENANCE OPERATIONS
T
O REPLACE THE PRINT HEAD
10. Close the operator console and put the handset back on its
support.
n o t e
If you have replaced the print head because the ink ran
out , when the operator console is closed, the fax machine
will automatically recognize that the print head has been re-
placed and the
display will show the message "NEW PRINT
HEAD? 1 = YES, 0 = NO". Set the value 1 .
At this point, the fax machine automatically cleans the print
head and tests the nozzles , printing out the result of the
diagnostic test. Examine the diagnostic test result with refer-
ence to "
Insert the print head ", chapter " How to get started
quickly ".
If you replaced the print head because of a deterioration in
printing quality , proceed as follows:
1. Press the key
until the display shows:
HEAD MAINTENANCE
2. Press the key:
The display shows:
NEW HEAD: ON
3. Press the key:
The display shows:
CLEANING: ON
The fax machine cleans the print head and tests the
nozzles, printing out the result of the diagnostic test.
Examine the diagnostic test result and consult " Insert
the print head ", chapter " How to get started
quickly ".
1. Lower the handset and place it
on a stable surface.
2. Open and lift the operator con-
sole as indicated by the arrows.
3. Release the print head by press-
ing the lever as indicated by the
arrow.
4. Remove the used print head from
its compartment.
5. Take the new print head out of
its package and, holding it on
both sides, peel off the film cov-
ering the nozzles.
Warning!
6. Avoid touching the electrical
contacts.
Warning!
7. Avoid touching the nozzles.
8. Insert the new print head in its
compartment with the electrical
contacts facing towards the print
head compartment.
9. Push the print head until it clicks
into place.