Oliver NC, Руководство пользователя по эксплуатации и инструкции

Страница: 21 / 49

690-NC2
0690S20046 6-2
Error Code Display (continued):
Er13-
O pen sensor Check for an open probe.
Zone 2/Bottom probe
open sensor
Er14-
Probe is out of range. Check probe for short.
Zone 2/Bottom probe Should be greater than
shorted sensor 90 ohm s.
Er15-
y
Faulty heater
y
Check heater elem ents
Zone 1 loop error
y
Shorted sensor
y
Check sensor probe
y
Bad heater contactor
y
Check switching device
Er16-
y
Faulty heater
y
Check heater elem ents
Zone 2 loop error
y
Shorted sensor
y
Check sensor probe
y
Bad heater contactor
y
Check switching device
Problem Probable Cause Solution
CAUTION
BEFORE WORKING ON A OVEN WHICH HAS BEEN RECENTLY USED
ALLOW SUFFICIENT TIME FOR IT TO COOL TO PREVENT BURNS.
SOLVING OTHER PROBLEMS
No Power.
•
The machine is not plugged in.
•
There is no power available at the outlet/disconnect
•
The circuit breaker has tripped. Reset by pressing the switch so that it is flush with
the front panel. (Control panel only)
•
A fuse has blown.
•
The transformer has failed. (Control panel only)
No Heat or Oven Heats Slowly
A cooled dry empty oven can be heated from room temperature to 300
°
F in four to six
minutes. If the oven is not meeting this specification, check the following.
•
Check the fuses
•
Check the two contactors.
No Heat or Oven Heats Slowly (Continued)