Oliver 688-N, Руководство пользователя по эксплуатации и инструкция

Страница: 17 / 39

MODEL 688-N
0688S20007 6-3
Changing a Bank of Heating Elements (continued)
•
Remove the electrical rear side panel by removing the 6 slotted head screws which
secure the cover.
•
Remove the wires from the ends of the bank of heating elements. Make sure they are
marked so that they can be returned to the new bank of elements easily.
•
Remove the four hex head screws which secure the bank to the housing and remove
the bank of elements.
•
The interior surface, where the bank of elements were previously attached, should be
cleaned completely of any remaining sealant.
•
A new bank of elements must be sealed to the housing using a NSF/FDA approved
silicone sealant.
•
Finish installing the new elements by reversing the above disassembly procedures.
Replacing the Door Gasket
•
Remove the 14 screws (including hinge screws) securing the inside and outside door
panels together.
•
Separate inside and outside door panels.
•
Lay the inside door panel down and remove the glass and gasket from the metal
frame.
•
Replace gasket using a NSF/FDA approved sealant between the metal and gasket.
and gasket end to end.
•
Set down door frame, rounded gasket side up and run a bead of NSF/FDA approved
sealant around top edge of entire gasket.
•
Place glass on top of gasket. This will seal the gasket to the glass.
•
Allow sealant to dry, (approximately four to five hours).
•
Replace door panel, clamp the front and back door panels together before tightening
the screws.