Oliver 688-N, Руководство пользователя по эксплуатации и инструкция, Страница: 9 / 39

MODEL 688-N
0688S20004 3-3
Electrical Connection (continued)
For voltages other than those shown below please contact the factory. Check the voltage
at the electrical disconnect before proceeding to the next step.
480 Volts = 20 Amp service
375 Volts = 20 Amp service
240 Volts = 30 Amp service
208 Volts = 30 Amp service
The oven is shipped from the factory with a power cord, which does not include a plug.
The power cord should be wired to a disconnect enclosure which is accessible from the
oven work area, leave at least two feet of slack so that access can be gained to the ovens
back and right side. A plug may be used between the disconnect enclosure and the oven
instead of hard wiring as described above. This makes sliding the oven out for service
more convenient. Whatever method is used the oven should be wired in a manner which
would conform to the U.S. “National Electric Code”.
CAUTION
FANS MUST ROTATE IN THE CLOCKWISE DIRECTION FOR PROPER AIRFLOW.
IMPROPER DIRECTION MAY CAUSE UNEVEN BAKES AND LONGER BAKING TIMES.
Check fan rotation for clockwise direction. After the oven has been “Set Up” and
connected to the electrical service do the following to check the rotation of the fans. Use
the following sequence to start the oven to check fan rotation direction:
•
Turn the main power switch on, (green button). The oven blower motor should
start. Once started the fan rotation can be checked.
•
Once complete, turn the main power switch off, (red button).
If the rotation is incorrect remove and interchange any two of the three incoming power
leads (red, white and black), at the plug or disconnect enclosure and retest.
Venting
The gap between the door and the housing of the model 688 oven is designed to be the
vent for the oven. SOME STEAM MAY ESCAPE THROUGH THE FRONT DOOR
GASKET.