Oliver 6320, Руководство пользователя, Страница: 27 / 56

6320 Sander OLIVERMACHINERY.NET 27 | Page
Contour Sanding with Side Table
1. To maximize dust collection efficiency, only
install the side table for contour sanding
work.
2. Loosen the lock knob to unlock the sanding
belt guard.
3. Use the buckle on top of the sanding belt
guard to keep the guard in the open position.
4. Install the side table lock knob onto the
mounting bracket.
5. Insert the end table post into the mounting
bracket. Align the groove of the post with the
lock knob.
6. Make sure the table is not catching the
sanding belt and the table is positioned at
least 1/16
” above the bottom edge of the
sanding belt. Tighten the lock knob to secure
the table.
7. After using the side table, remove it from the
sander. Close and lock the sanding belt
guard.
WARNING
Avoid sanding edges with curvature
closely matching the abrasive surface.
Failure to comply increases the risk of a
catch, which can cause severe injuries
and damage to the workpiece.
IMPORTANT
Only remove the belt guard and install the
side table while performing contour
sanding. Keeping all belt guards installed
at most times improves dust collection
effectiveness for edge sanding and
reduces the risk of accidental body
contact with the sanding surface and
moving parts.