
22 |
Page
Oliver Machinery
6320 Sander
Electronic & Electrical Components Testing
1.
Put on safety goggles and hearing
protection.
2.
Before connecting the sander to a power
source, press the emergency stop button to
prevent the machine from starting
unintentionally.
3.
Connect the machine to power.
4.
Make sure the belt tilt digital readout is
turned on. When changing the tilt angle of
the sanding belt, the value on the readout
should change accordingly.
5.
Move the belt to the upright position and
lock the belt tilt angle before moving to the
next step.
6.
Turn the belt oscillation speed dial to 0.
7.
Attempt to turn on the machine by pressing
the
“
START
”
button. The motor should not
start as the emergency stop button is not
reset.
8.
To reset the emergency stop button, turn
the button clockwise until it pops up.
9.
Press the start button, and the motor should
start. If the sanding belt is tracking within
the platen and stays at least 1/16
”
below the
table, increase the oscillation speed and
continue to observe the movement of the
sanding belt. The belt should now move up
and down but still track within the platen
and stay at least 1/16
”
below the table.
If the sanding belt is not tracking properly,
TURN OFF THE SANDER IMMEDIATELY.
See
on page 32 to
adjust belt tracking.
10.
Allow the machine to run for a minute.
During the initial run, a small amount of
loose graphite may fall off from the platen.
That is part of the break-in process, and it is
expected. Remove the graphite flakes with a
vacuum cleaner.
11.
While the sander is running, disconnect the
machine from power, then reconnect the
machine to power. The sander motor should
not start automatically as the magnetic
power switch automatically opens the
circuit when the power is out. Press the
“
START
”
button to restart the motor.
12.
Press the
“
STOP
”
button to stop the main
motor. Please note that unless the
emergency stop button is pressed, the
oscillation motor must be shut down by the
oscillation speed dial.
Congratulations! You have completed the test run. If you discover any issues from the tests, refer to the
troubleshooting section and maintenance section to diagnose issues and make adjustments.
Содержание 6320
