600-R3 SERIES DOUGH MOULDER
0600S20009.doc Rev. 5/2/02
4.3 Changing the V-Belt
Should the V-belt drive on the motor become loose and begin to slip it can be tightened
simply by adjusting the motor bracket frame, see below.
1. Remove the back cover. Remove the orange handle bar (right side only). The two
nuts securing the handle bar are located on the inside of the frame. Remove the
right side plastic housing, (Item #234, Not shown, Refer to Item #235, Drawing
5.1.1).
2. Loosen the motor adjustment lock down screw.
3. Lift the motor and bracket to allow removal of the belt.
4. To reassemble simply reverse the above procedure.
5. After installing the belt run the machine a few minutes and recheck the belt for
proper tightness before replacing the side housing.
V-Belt and Motor Replacement
4.4 Replacing the Motor
1. Remove the V-belt, (Section 4.3, Procedures 1 through 3).
2. Remove the wires and the pulley from the motor. Remove the screws securing the
motor to the motor bracket and then pull the motor out from the machine.
3. Replace the motor by reversing the above procedure. Be sure to check that the
replacement motor is rotating in the proper direction before reinstalling the V-belt and
covers.
4-2
