600-R3 SERIES DOUGH MOULDER
0600S20009.doc Rev. 5/2/02
NOTE
ALWAYS REPLACE THE BEARINGS WITH NEW ONES WHENEVER THEY HAVE
BEEN REMOVED FROM MACHINE.
4.6.2 Removing the Lower Adjustable Sheeting Roller
1. Follow all the procedures in section 4.6. The intake cover will need to be completely
removed at this time.
2. Remove the left and right lower scraper tension springs, (Item #811, Drawing 5.1.1),
and then disengage the lower scraper (Item #804, Drawing 5.1.1) by pushing it to the
right and lifting it out.
3. Remove the lower timing belt pulley, (Item #325, Drawing 5.1.2) from the left end of
the roller
4. Loosen the screw on the left hand rocking device, (Item #212, Drawing 5.1.2) that
locks the left hand bearing in placs.
5. Remove the small retaining snap rings from both ends of the roller shaft. Using a
puller, push the right end of the roller shaft out of the right hand bearing. Once the
left hand bearing has cleared the left hand rocking device, remove the left hand
bearing. The lower sheeting roller can now be removed from the machine by
pushing the roller to the left until the right end is free. Lift the right end of roller out
from the machine and slide the roller completely to the right and out from the
machine.
6. Reassemble by reversing the above procedure.
NOTE
ALWAYS REPLACE THE BEARINGS WITH NEW ONES WHENEVER THEY HAVE
BEEN REMOVED FROM MACHINE.
4-5
