Oliver 10014, Руководство пользователя

Страница: 48 / 65

48 | Page Oliver Machinery 10014 Planer
Troubleshooting
Problem Possible Cause Possible Solution
Machine does not start. Stop button is not
reset.
Turn the rim of the STOP button clockwise to
reset. The stop button will pop up.
Machine is not
connected to a power
source.
1. Make sure machine is plugged in, or power
disconnect is at the ON position.
2. Check electrical panel for tripped circuit
breaker or blown fuse.
3. Ensure all electrical connections have good
contacts.
Low voltage / current. Have an electrician to check/repair the power
circuit.
Faulty switch/motor/
capacitor.
Contact customer service for further assistance.
Machine trips thermal
protection / circuit
breaker, or blow fuses.
Machine is undersized
for the operation.
Reduce the depth of cut and/or feed rate.
Workpiece moisture
level is too high.
Only plane wood with moisture level below
20%.
Machine is jammed. Inspect cutterhead and make sure it is not
obstructed by woodchips. Check dust port and
headstock and clear blockages.
Too much load on a
circuit.
Make sure the power circuit is sized for this
machine. If the same circuit is shared, ensure
the circuit is sized to supply power for all items
in the circuit.
Motor/capacitor issue. Contact customer service for further assistance.
Machine stalls during
operation.
Machine is undersized
for the operation.
Reduce the depth of cut. Lower feed rate.
Dull cutters Rotate/replace cutter inserts.
Belt slipping Clean belt and the pulleys. Adjust belt tension.
Motor/capacitor issue. Contact customer service for further assistance.
Machine stopped
during operation.
Thermal overload
protection triggered.
Hit STOP button to reset overload protection.
Wait for the machine to cool down. Reduce
depth of cut and feed rate before continue.
Chain jumps during
operation.
Loose chain. Replace chain.
Misaligned sprockets. Align sprockets.
Worn sprockets. Replace sprockets and chains.
Digital readout not
functional.
Dead battery. Replace battery.