Oliver 10014, Руководство пользователя

Страница: 47 / 65

10014 Planer OLIVERMACHINERY.NET
47 |
Page
If the workpiece is damaged by the feed roller,
reduce pressure.
Adjust Cutterhead Height Scale
The cutterhead height scale is pre-calibrated at
the factory. It can be adjusted to accommodate
a different viewing angle, or if the scale is
shifted.
1. Prepare a piece of 2x4 with flat bottom for
calibration.
2. Using the digital readout, plane the board
down to 1-1/4” or 1”. Use a caliper to
measure the mid-section of the board for
thickness.
3. Loosen the top and bottom screws that
holds the scale in place.
4. Shift the scale so that the pointer is
pointing at the exact value as the thickness
of the board.
5. Re-tighten the screws when adjustments
complete.
Anti-Kickback Fingers Inspection
This planner is equipped with anti-kickback
fingers. Once engaged, the workpiece can only
move towards the cutterhead. This prevents
accidental kickbacks which can cause serious
injuries.
Inspect the anti-kickback fingers regularly to
ensure they can move freely, and that their
teeth are clean and are sharp enough to stop a
board from moving backwards. Clean and
lubricate with very light coat of SAE-30 machine
oil as needed.
Replace anti-kickback fingers if they are
damaged or worn.
CAUTION:
Do not operate this planer
without functioning anti-kickback fingers.
Failure to comply can result in serious
personal injuries.