10014 Planer
OLIVERMACHINERY.NET
45
|
Page
7.
Move the dial indicator to the lowest point
of the feed rollers. The reading from the
dial indicator now shows the offset
between the cutterhead and the roller.
Made adjustments if the offset goes
beyond the tolerance listed below.
Tolerance
Infeed Roller
0.020” - 0.027”
below
Chip breaker
0.000” - 0.020” below
Outfeed Roller
0.024” - 0.031” below
8.
To adjust the height of the feed rollers,
loosen the jam nuts on both ends of the
feed roller. Rotate the set screws to change
the height of the roller. Continue to
calibrate until the cutterhead-roller offset is
uniform across the entire feed roller.
9.
When the correct height is set, hold the set
screws in place and re-tighten the jam nuts.
10.
Re-install belt cover when adjustments
complete.
Method 2: Using Feeler Gauge
1.
Using hardwood, build a gauge block similar
to this one below. The exact dimension is
not critical. Just make sure the bottom
clears the table roller. The top should be
chamfered for better tool access and
visibility.
2.
Remove all tools from the planer.
3.
Turn on the planer, wait until it reaches full
speed, then shift the feed rate control knob
to 0 FPM (Neutral) position.
4.
Turn off planer.
Disconnect planer from
power source!!
5.
Remove the belt cover so you can rotate
the cutterhead with the drivebelt.
Содержание 10014
