Oki OKIPAGE 24DX, Руководство по обслуживанию

Страница: 195 / 424

Informs that a jam occurs after
ejecting a paper. Open the cover
and remove the paper inside. Open the cover, remove the
paper, then close the cover.
When the cover is closed,
recovery printing is performed
and the error display is released.
If the error occurs frequently,
see Section 6.5.2.
Informs that OKI HSP I/F card is
under reset. It can be
automatically restored by
stopping the reset. Warning
Informs that an error (significant
malfunction) occurs. The
operation is continued by
pressing Recover switch.
xx: 10 - I/F timeout
20 - Initial error occurs 10
seconds later since powering on
21 - In the event that it takes 3
seconds or more for shifting to
the operating mode, or a
command for operating mode is
received during power on mode.
22 - Communication error
between OKI HSP - host. Press RECOVER key. If the
error occurs frequently, check
HSP card.
Informs that the upper cover is
open. Close the cover to release the
error display. If the display does
not change after the cover is
closed, check for correct
operation of cover opens/switch
and lever. Replace the Power
Supply Unit (High Voltage).
Indicates that an error from the
results of checking ID No. of
EEPROM. The operation is
continued by resetting EEPROM
to factory default
after-a-few-second indication. It displays the message for a few
seconds. It reset the EEPROM
to the factory default state to
continue operation.
* When the program ROM is
updated and the EEPROM is
replaced with a new one, the
menu factory default
corresponding to each
destination will be loaded.
Category: Controller error
LCD message: ERROR CONTROLLER nn-aaaaaaaa
READY LED: Light off
ATTENTION LED: Flash
Trouble or status Remedy