Oki CX4545 MFP, Руководство по копированию

Страница: 14 / 194

1 BEFORE USING EQUIPMENT
12 Placing Paper
*8 Note that black streaks may appear on the edge of the printed sheets.
*9 If an optional finisher has been installed, the upper receiving tray of the Finisher MJ-1101 and the Saddle Stitch Finisher MJ-1106, and the
receiving tray of the equipment are used for paper exiting.
*10 When paper is exiting, remove one sheet after another from the tray of the Hanging Finisher MJ-1031 (optional), since it may fall off the tray.

“LT format” is the standard size only for use in North America.
 “K format” is a Chinese standard size.
 Abbreviations for paper sizes: LT: Letter, LD: Ledger, LG: Legal, ST: Statement, COMP: Computer, SQ: Square
 Unacceptable copy paper
Do not use the types of paper shown below. This could cause a paper jam.
 Damp paper
 Folded paper
 Curled or creased paper
 Paper whose surface is extremely smooth or rough
Do not use the types of paper shown below. This could cause an equipment malfunction.
 Paper whose surface has had special treatment
 Paper once printed with other copiers or printers
 Precautions for storing copy paper
Make sure of the following when storing copy paper:
 Wrap the paper in its wrapping to keep it free from dust.
 Avoid direct sunlight.
 Store in a damp-free space.

To prevent paper from being folded or bent, store it in a flat place.

Placing paper in drawers
Follow the procedure below to place paper in a drawer. For acceptable copy paper, see the following page:
 P.11 “Acceptable copy paper”
1
Turn the power of this equipment ON.
2
Pull out a drawer carefully until it comes to a stop.
3
Push the lower part of the end guide in the direction
of the arrows to remove it, then reinstall it at the
position of the desired paper size.
The paper size is indicated on the bottom inner surface of the
drawer.