- 24 -
Problem
Cause of Problem
Troubleshooting
3 . T h e f l o w o f s c r e w s h a s
stopped.
○ The screws are the wrong size for the rail.
○ There are not enough screws in the
scooping chamber.
○ A screw is stuck between the passing
plate and the rail groove and the brush
cannot remove it.
○ A screw is stuck on the rail.
○ Use screws appropriate to the rail
size.
○ Place screws into the scooping cham-
ber.
○ Adjust the brush.
○ Adjust the passing plate.
○ Place screws into the scooping cham-
ber.
○ Replace the driving belt.
○ Use a hard brush. (optional)
○ Remove the screw.
Follow the procedure below.
Pull up the holding plate and remove
the screw. Then adjust the hold-
ing plate position. Be careful not to
scratch the rail.
