OHTAKE OM-26RB Series, Руководство по эксплуатации

Страница: 14 / 24

－
13
－
５－ 8．
Check and adjust the passing plate
５－ 9．
Check and adjust the holding plate
・
Check that the clearance between screws in the rail groove and the
holding plate is about 0
～
1mm.
・
If any adjustment is required, loosen the holding plate attaching screw
and turn the holding plate adjusting screw, to move the plate up or
down.
・
If there is no clearance, a screw will be blocked. If the clearance is too
large, screw piling or screw jump out will occur.
When the holding plate adjusting screw is turned clockwise,
the plate moves down.
When the adjusting screw is turned counterclockwise,
the plate moves up.
Turn OFF the power switch before starting replacement and
adjustment.
Up Down
Passing plate
Passing plate
attaching bolt
Loaded
screws
The clearance should be just enough to permit the loaded screws to
pass through the passing plate.
Holding plate
adjusting screw
H o l d i n g p l a t e
attaching screw
(inside of the hole)
・
Check that the passing plate is adjusted to a height that permits
loaded screws to pass just within the limit.
・
If the passing plate is too low, screws cannot pass. If the passing plate
is too high, it will hamper a smooth transport of the screws.
・
If adjustment is required, loosen the passing plate attaching bolts and
adjust either up or down.