OHTAKE NJ-2320, Руководство по эксплуатации

Страница: 10 / 26

Employed
screw
V groove
Stopper
Bit guide
Bit guide mounting screws
４
-
６．
Checking and Adjusting the Bit Guide
Place five to ten screws in the rail and tilt this machine until they hit the stopper on the rail as-
sembly.
When the internal shutter is closed, the screws cannot go through the passage plate.
If it is closed, turn the timing shaft clockwise with the Allen wrench to keep it open.
The stopper is fixed to the rail assembly. The adjustment of the stopper is made by moving
the rail assembly front and rear. If the “V” groove on the bit guide and the rear point of the
Phillips screw head are not aligned, adjust as follows:
Loosen the bit guide mounting screw with the Allen wrench and move the bit guide forward
and back to put them in alignment.
Please remember to tighten the screws after adjusting.
-
８
-