OHTAKE NJ-2320, Руководство по эксплуатации

Страница: 19 / 26

-
１７
-
Problem
Cause Remedy
7-4
The screws on the
rail do not feed
smoothly.
-The clearance between the holding plate
(screw guide 1) and screw heads is
insufficient.
-Dirt, oil, or grease is attached to the rail.
-The rail fails to vibrate due to a screw or
foreign object trapped in the opening.
-Shift the holding plate (screw guide 1) upward.
Use the Quicher in a tilted position.
Adjust the timer setting control.
-Clean the rail and rail guide.
-Remove the trapped screw or foreign object and then
clean the rail and rail guide.
7-5
Oddly oriented
screws occasionally
travel through the
passage window.
A screw shank easily
gets caught in the
passage window.
-The passage plate is improperly adjusted.
-The employed passage plate does not
match the applied screw.
-The forward-descending tilt of the machine
is
above the permissible limit.
-Readjust the passage plate.
-Use the passage plate that matches the applied screw.
-Adjust the tilting angle,make sure it is within the
permissible limit.
7-6
Screws are not
transported to the
removal section.
-Screws are stopped in the middle of the
rail section.
-Screws are not smoothly delivered from
the rail to the front stopper.
-Readjust the holding plate (screw guide 1).
-Readjust the passage plate.
7-7
The bit doesn't
match the Pillips
head.
-The rail assembly is improperly adjusted.
-The bit guide is improperly adjusted.
-Readjust position between the rail and bit guide.