OHAUS EXPLORER, Руководство по обслуживанию

Страница: 18 / 114

2-4
CHAPTER 2 DIAGNOSIS
Displays Err 8.5
Internal calibration weight sensor indicates the weight is on the pan, Check the connection between the calibration
unit and the main PCB. Could be a problem with the calibration mechanism or the main PCB.
Displays Err 9.1
Personality data corrupt. Reload using EP Loader.
Displays Err 9.2
Serial number does not match. The serial number chip U10 was not transferred to a new PCB. If the correct U10
can not be found the main PCB must be replaced with a configured PCB.
Displays Err 9.3
Serial number does not match. Unplug and try again. If that fails reload personality data using EP Loader.
Displays Err 9.4
Factory internal calibration data failed checksum. Perform MFG and MFGWT. If the problem persists reload the
TC data. If the problem still persists the main PCB must be reconfigured at Ohaus.
Displays Err 9.5
Factory calibration data failed checksum. Perform MFG and MFGWT. If the problem persists reload the TC data.
If the problem still persists the main PCB must be reconfigured at Ohaus.
Displays Err 9.8
User calibration data failed checksum. Perform MFG Calibration. For units with internal calibration also perform
MFGWT.
Displays Err 9.9
Can not be fixed in the field, the unit has to be temperature compensated.
TABLE 2-2. EXPLORER VOYAGER ERROR CODES (Cont.)
TABLE 2-3. INFORMATION MESSAGES
CAL NOW If InCAL
TM
(internal calibration) is installed. Message to recalibrate the balance. The message will remain
until calibrated.
WARM UP The user tried to perform an internal calibration and this message will be flashed in the 14 segment field.
The balance requires a 7 minute warm-up period. During warm-up, the user cannot select InCAL
TM
from
the menu.
SAVED This message is flashed when an item is changed in the menu and the new value is written to the
EEPROM.
LOCKED This message is flashed when an item cannot be changed in the menu, because the menu is locked and
the Lock Switch is set locked.
LOW REF The message is flashed in parts counting or percent when the calculated reference weight is very low.
2.3 EXPLORER / VOYAGER ERROR CODE TABLE (Cont.)