OFITE, 11302 Steeplecrest Dr., Houston, TX 77065 USA / Tel: 832-320-7300 / Fax: 713-880-9886 / www.ofite.com
7
Quick Start
1. Plug in to appropriate electrical outlet.
2. Flip the “Heat” switch on the control panel ON. The red light pulsates
when temperature is reached. This also turns on the circulating fan.
3. Flip the “Motor” switch on the control panel ON. The white light comes on
and the rollers begin turning.
Programmable Timer
To set the correct local time:
1. Turn the “Heat” switch on the control panel to the ON position.
2. Set the “Out 1 switch - On-Auto-Off” to the AUTO (middle) position.
3. Set the “P1, P2, Run” button to P1 to activate programming mode for
Output 1.
4. Open the panel door and press and hold the “TIME ADJ” button until a
blinking clock appears.
5. Press the “h” and “min” buttons to set the correct local time.
6. Press “WRITE” when finished.
7. Set the “P1, P2, Run” button to P1 to show the time.
To program the timer:
1. Turn the “Heat” switch on the control panel to the ON position.
2. Set the “OUT1” switch - On-Auto-Off” to AUTO setting. Leave the
“OUT2” switch off.
3. Set the switch to the right of the display to P1 to activate programming
mode for Output 1.
4. Select the day of the week for each the ON/off operation, marked by
the removal of a dash above the day of the week button.
5. Press the “h” and “min” buttons to set the correct time for the “ON” or
beginning cycle to begin. The “UP” arrow will blink.
6. Press “Write” to activate the Turn Off time (The Down Arrow Blinks).
7. Select the day of the week for each the on/OFF operation, marked by
the removal of a dash above the day of the week button.
8. Press the “h” and “min” buttons to set the correct time for the “OFF”
cycle to end. The “DOWN” arrow will blink.
