OFITE, 11302 Steeplecrest Dr., Houston, TX 77065 USA / Tel: 832-320-7300 / Fax: 713-880-9886 / www.ofite.com
13
Programming:
1. Turn the “Heat” switch on the control panel to the ON position.
2. Set the “OUT1” switch - On-Auto-Off” to AUTO setting. Leave the
“OUT2” switch off.
3. Set the switch to the right of the display to P1 to activate programming
mode for Output 1.
4. Select the day of the week for each the ON/off operation, marked by
the removal of a dash above the day of the week button.
5. Press the “h” and “min” buttons to set the correct time for the “ON” or
beginning cycle to begin. The “UP” arrow will blink.
6. Press “WRITE” to activate the turn off time (The down arrow blinks).
7. Select the day of the week for each the on/ OFF operation, marked by
the removal of a dash above the day of the week button.
8. Press the “h” and “min” buttons to set the correct time for the “OFF”
cycle to end. The “DOWN” arrow will blink.
9. Press “WRITE” when finished.
10. Set the switch (“P1, P2, Run”) to the right of the display to “RUN”.
The bar (-) will display the day(s) of operation.