22 of 44
Subject to change without notice
OC15269 REV F
www.octopusdrives.com
www.octopuseurope.com
• Fit the clevis block to the secondary steering cable rod end
i) Remove the hitch pin from the clevis
block pin.
ii) Remove the nut, 2 x anti-vibration
washers and bolt from the clevis block.
ii) Insert the cable rod end into the slotted
hole in the clevis block. Ensure the
clevis block is correctly oriented as
shown, with the clevis pin pointing
down (Fig B28).
iv) Fit the bolt through the bottom of the
clevis block, through the cable rod end
and out the top of the block. Fit the
anti-vibration washers in the correct
order, with the serrated face of the
washer in contact with the the nut face
and the clevis block face. The cam
face of the washers must be in contact
with each other.
v) Tighten the locking nut and torque to
180-200in-lb (20-22.5Nm). The screw
has a locking thread which increases
the amount of torque required initially
as the thread is cut.
Clevis
block
Fig B28 - Fitting the clevis block to the
secondary cable rod end
Hitch
pin
Serrated
faces
Cam
faces
Rod
end
