Ochsner AIR BASIC 109, Руководство по эксплуатации/Инструкция по установке

Страница: 50 / 92

BA_AIR_BASIC_ELW_Multitower_OTE3_SW5x_CC_EN_V08.docx Page 50 of 92
6.3 Wiring diagrams
6.3.1 AIR BASIC 109
Figure 62: AIR BASIC 109 wiring diagram
All wiring/cables must be flexible (ÖLFLEX).
CAUTION Schematic diagram: The schematic does not include all fittings/safety elements/components
required for installation. Install the system according to relevant standards and local guidelines!
KEY:
A)
Outdoor unit terminal box
B) Indoor unit
C) Meter/distributor
1) Outdoor unit supply
1x 220-240 VAC 50 Hz /N/PE
2) PSU cable (remove the factory-fitted jumper)
3) Control cable 240 VAC
4) Supply of integral 5.9 kW E-rod
5) Bus connection between indoor and outdoor
unit, lay the screen on both sides!
6) Outdoor sensor
7) Vers.A: Booster heater with 3~ supply
8) Vers.B: Booster heater with 1~ supply
Protection of 1 with 16 A C fuse protection.
Protection of 4 with 16 A C fuse protection.
Always make the signal contact when tariff
switching by the PSU (power supply utility) is in
operation!
Provide wiring at
A) with 50 cm excess length.
This allows removal of the switching plate and
thus enables servicing.
NOTE
All cables should be sized by the electrical
contractor according to local conditions.