27
2.
For operation of Colours, consult the relevant DMX controller manual.
6.2 - Maintenance
1.
Marine growth can build up quickly on the light and can reduce the performance in just a few
weeks. To help prevent this, all OceanLED lights have been coated with a specialized Tritonium® coating
which makes the surface of the glass lens a non-stick layer. Lights should be cleaned with a boat brush or
similar biweekly, or as needed to keep the lens of the light clean. Growth varies greatly around the world
and maintenance is imperative to the proper operation and longevity of the product. If heavy fouling
occurs, barnacles can be removed from the lens using a plastic scraper and moderate pressure under water.
If cleaning the lens while the boat is out of the water, apply water to the lens before scraping. Never scrape
or try to remove barnacles from a dry lens.
Warning
:
Harsh cleaning solvents such as acetone may damage the light. Using a harsh solvent on the
light may invalidate your warranty.
2.
Check connections annually for corrosion, if necessary, replace connections.
3.
Check light installations periodically for signs of corrosion.
6.3 Removing light cartridge from mounting tube
Warning:
Before attempting to remove the Insert from the mounting tube, be sure to check that the
lens on the unit has not cracked and leaked water into the light unit. If the lens or seals have been
compromised, do not remove the insert whilst the boat is in the water. Contact your local OceanLED
representative for more Information (If lens becomes damaged then a replacement unit is required).
6.3.1 Removing the light cartridge 50 XFM HD
1.
Turn the power off that supplies the light units.
2.
Disconnect the light from the driver.
3.
Unclip retainer.
4.
The light insert is now ready for removal. Pull out from mounting tube twisting to break seal.
NOTE:
Do not remove O ring or tamper with the mounting tube as this may cause damage.
6.3.2 Removing the light insert Allure 150 & 250 XFM HD
1.
Turn the power off that supplies the light units.
2.
Disconnect the light from the driver.
3.
Remove rear locking ring using locking ring spanner provided.
OceanLED INSTALL / ALLURE / 240717 / 7.1
