22
Tip
: Always use dielectric grease when making the connections to the light. Corrosion of wire is NOT covered
under warranty.
3
Connect the Deutsch plug from the light into the multi pin port on the driver.
4
If you are not installing a custom fuse panel, it is imperative that a correctly rated fuse is installed on the
power line from each light. Please consult electrical specification on page 4 to select the correct fuse.
5
Using waterproof connections or a waterproof junction box, make the connections from the fused
24V DC power source to the 2 core power cable (RED is positive, BLACK is ground).
6.
Continue to section 5.5 for DMX control connection
5.4
Installation of Colours AC DMX Driver
Additional items required (not supplied)
• Screws to secure the driver
• Junction box / waterproof connectors
• Sufficient cable to connect to power lead.
• Suitable fuse / breaker(s)
• DMX controller (1 per system)
• DMX terminator (1 per system)
Warning
: Always consult a qualified electrician when connecting OceanLED light fixtures.
Warning
: Never use power tools to secure the drivers: hand tighten only.
Warning
:
Brown=Live; Blue=Neutral; Green/Yellow=Earth
Warning
: When connecting light units, please note that all OceanLED lights will operate within a specific
voltage range. Please check the electrical information to ensure cable gauge, fuse recommendations, break-
er size etc.
Driver connections
• The 3 core input is for the power
• The multi pin Deutsch connector is for the light
• 2x DMX connections (DMX in / DMX out)
Warning
: Mount drivers in a dry location. Drivers should not sit in standing water at any time.
1.
Fix driver into required position, see below diagram for mounting dimensions and clearances. Ensure
chosen driver location is near enough to connect light cable without applying undue stress
OceanLED INSTALL / ALLURE / 240717 / 7.1
