3
IMPORTANT SAFETY PRECAUTIONS!
!
IMPORTANT NOTICE
: Attention Installer:
This manual contains important information about
the installation, operation and safe use of this product. This information should be given to the owner and/
or operator of this equipment.
CAUTION
-
(Risk Group 2): Possibly hazardous optical radiation emitted from this product. Do not
stare at operating lamp. May be harmful to the eye.
!
WARNING
•
Before installing your OceanLED Light, read and follow all warning notices and instructions which are
included. Failure to follow safety warnings and instructions can result in property damage, severe injury
or even death.
•
Before installing your OceanLED Light, check local laws for restrictions regarding the use of colored
lights in your area.
•
Do not operate lights out of water for a period longer than 5 minutes. Exceeding this may cause
damage to the light unit
•
Ensure the bonding point of the light is fitted to the cathodic protection system on the vessel. Check
conductivity between earth bonding point and aluminium bronze front bezel. If mounting the light
to metal or carbon fibre hull, ensure that suitable measures have been put in place to account for the
effects of galvanic corrosion i.e. use of delrin sleeve components.
•
Salt is an inherently corrosive material. Metal parts and certain natural and man-made surfaces are
particularly susceptible to corrosion and deterioration when used in and around salt water. Some
OceanLED lights contain combinations of plastic and polymer products which are impervious to salt
water corrosion, however, screws and fasteners used for the installation must be of a marine grade type
stainless steel or equivalent and monitored annually to ensure the lights remain in service for years to
come.
•
Never connect/disconnect lights to the driver with power applied as irreversible damage may occur.
•
Never Use Solvents! Cleaners, fuel, and other products that may contain strong solvents, such as
acetone, that attack many plastics greatly reducing their strength and irreversibly damaging the special
lens coatings and cable sheathings
DANGER! Risk of Electrical Shock or Electrocution!
This underwater light must be installed by a licensed or certified electrician in accordance with all
applicable local codes and ordinances. Improper installation will create an electrical hazard which
could result in death or serious injury to swimmers, installers, or others due to electrical shock, and
may also cause damage to property. Always disconnect the power to the light at the circuit breaker
before servicing the light. Failure to do so could result in death or serious injury to serviceman,
swimmers or others due to electrical shock. READ AND FOLLOW ALL INSTRUCTIONS IN THIS
MANUAL.
OceanLED INSTALL / ALLURE / 240717 / 7.1
-
