28
Warning
:
REMOVAL WITH INCORRECT TOOLS MAY DAMAGE THE UNIT AND INVALIDATE WARRANTY.
4.
The light insert is now ready for removal. Pull out from mounting tube using a slight twisting motion
to break seal.
NOTE:
Do not remove O ring or tamper with the mounting tube as this may cause damage.
6.4 Fitting or Replacing your XFM HD light cartridge
Installing or replacing the 50 XFM cartridge
1.
Check that the O-ring is fitted on the rear of the light cartridge, not damaged and free from debris.
2.
Ensure inside of mounting tube is clean and free of any moisture.
3.
Insert the light cartridge into the mounting tube. Slide in completely until the retainer clip aligns with
the groove in the light cartridge.
4.
Secure with retainer clip.
NOTE:
Verify that the light assembly is still conected to the bonding/cathodic protection system of the
vessel (See Chapter 3 and 4)
Installing or replacing the 150 or 250 XFM cartridge
1.
Check that the O-ring is fitted on the rear of the light cartridge, not damaged and free from debris.
2.
Ensure inside of mounting tube is clean and free of any moisture.
3.
Insert the light cartridge into the mounting tube. Slide in completely until it comes to a stop.
4.
Fit rear locking ring on to mounting tube.
5.
Hand tighten onto outer mounting tube, then using locking ring spanner secure fully.
NOTE:
Verify that the light assembly is still conected to the bonding/cathodic protection system of the
vessel (See Chapter 3 and 4)
Replacement Parts
Lost, broken, and worn parts should be replaced immediately and can be obtained through your dealer or
from the manufacturer (Only use genuine OceanLED parts).
OceanLED INSTALL / ALLURE / 240717 / 7.1
