19
179mm
108mm
52mm
Tip
: For complete instructions on V DC connections, please refer to local codes and ordinances for V DC con-
nections. or equivalent
Warning
: Never leave the bare cables unprotected. Water deposits in the connectors and cables will corrode
the cables causing the light to fail and will NOT be covered under warranty.
2.
Depending on the model and quantity of lights installed you will need to pull the correct sized power
cable from the breaker to the driver locations to supply constant power to the units. It is imperative that
the correct sized tinned marine cable is used. (Refer to Cable Gauge Chart in Appendix).
Tip
: Incorrect cable gauge will drop voltage along distances. Decreases in voltage will increase current demand
by the driver unit and will lead to blown fuses and tripped breakers. DO NOT compensate for this by adding
higher rated fuses and/or breakers. Fuses are designed to protect the wiring, not the components.
Tip
: Always use dielectric grease when making the connections to the light. Corrosion of wire is NOT covered
under warranty.
3
Connect the Deutsch plug from the light into the multi pin port on the driver.
4
If you are not installing a custom fuse panel, it is imperative that the OceanLED supplied fuse is installed
on the power line from each light. Please consult electrical specification on page 4 to select the correct
fuse, dependant on which model of light you have.
5
Using waterproof connections or a waterproof junction box, make the connections from the fused V
DC power source to the 2 pin power pigtail (RED is positive, BLACK is ground). Plug the 2 pin power
connector into driver
6.
Secure cables to finsh and test light units BEFORE the boat goes into the water.
NOTE:
Do not run
light(s) for longer than 2 minutes to avoid damage. If you have any issues and need troubleshooting
advice, please contact your local OceanLED representative.
7.
See section 5.6 for finalizing the installation of OceanLED Lights.
OceanLED INSTALL / ALLURE / 240717 / 7.1
