Oceanic Magellan-2200, Руководство оператора, Страница: 14 / 52

14
The following labels are fitted on the ventilator module:
• Ventilator Panel Label: Part No – 504-351
• Patient monitoring port identification label: Part No – 504-353A
• Gas supply port identification label: Part No – 504-353B
• Interconnection port identification label: Part No – 504-353C
• Federal law label: Part No 504-1166NUS
• Alarm Bezel Label (set of 2): Part No – 504-222
And the following fitted labels on the compressor module:
• Compressor panel label: Part No - 504-352
• Battery fitting and removal instruction Label: Part No – 504-223
WARNING: Failure to read this user’s handbook before first use of this device may
result in death or serious injury.
WARNING: To avoid harm to the patient, pre-use checks must be performed in
accordance with section 4 of this manual before each use.
WARNING: Always ensure that an alternative means of ventilation is available in the
event of ventilator failure or malfunction.
All operators should receive a full and proper initial and ‘refresher’ instruction from a
qualified person, both on resuscitation and on detailed use of the equipment in the
particular situations in which it might be employed.
WARNING: To avoid harm to the patient, this equipment should only be used by
personnel trained in the use of automatic ventilation.
Information given in this manual beyond the basic operation of the comppac ventilator is
only intended as a guide to supplement proper training and to indicate the specific
operational requirements of the comppac. The comppac ventilator is intended for use in
anesthesia by users who are appropriately trained and where the patient is being
constantly monitored.
WARNING: Failure to constantly monitor the patient whilst using this equipment,
may lead to death or serious injury.
Although use of this ventilator outside the environmental conditions specified in this
Manual will not directly lead to a safety hazard the performance will become increasingly
uncertain as the conditions become more extreme. Therefore the operator must exercise
constant patient vigilance under these conditions.
WARNING: Blood gas levels must be monitored independently, correct operation of
the ventilator will not necessarily achieve the required blood gas levels. Also, when
used at moderate altitude, it is essential that the user closely monitors delivered
tidal volume, and measures end-tidal CO
2
using suitable capnography.
(b) WARNINGS AND CAUTIONS
(i) WARNINGS
Warnings are given to make you aware of dangerous conditions, that could lead to death
or serious injury to the user or patient, that can occur if you do not obey all of the
instructions given in this manual.
The following Warnings highlight aspects of the use of the comppac ventilator that
require particular emphasis. The section of this manual referenced in each clause provides
the relevant context:
1.WARNING: Failure to read this user’s handbook before first use of this device may
result in death or serious injury (Section 1(a)).
2. WARNING: To avoid harm to the patient, pre-use checks must be performed in
accordance with section 4 of this manual before each use (Sections 1a) & 3b)).
3. WARNING: Always ensure that an alternative means of ventilation is available in
the event of ventilator failure or malfunction (Section 1a) & 4).
4. WARNING: To avoid harm to the patient, this equipment should only be used by
personnel trained in the use of automatic ventilation (Sections 1(a), 3(a), 4(a), &
4g)).
5. WARNING: Failure to constantly monitor the patient whilst using this equipment,
may lead to death or serious injury (Sections 1(a) & 4b)ii)).
6. WARNING: Blood gas levels must be monitored independently, correct operation
of the ventilator will not necessarily achieve the required blood gas levels. Also,
when used at moderate altitude, it is essential that the user closely monitors
delivered tidal volume, and measures end-tidal CO
2
using suitable capnography
(Section 1(a)).
7. WARNING: To avoid the potential risk of explosion associated with re charging the
Lithium version of battery, ensure that only a Ni Cad battery (Part No: 510-A1490/
CE, NATO No: 6140-99-620-8057) is installed. UNDER NO CIRCUMSTANCES SHOULD
THE LITHIUM BATTERY (NATO No: 6135-99-840-0109), OR ANY OTHER PRIMARY
BATTERY, BE FITTED. (Sections 2c), 2d) #14, 2d #15, 2e) iii), 3a), & 5b)).
8. WARNING: To avoid malfunction of the ventilator when using the battery as a
power source, periodically check the battery to ensure that there is sufficient
charge to power the ventilator. The battery may be trickle or fast charged using
the PS11 power supply/ charger unit (see section 2e) iii), however, this should be
undertaken in advance of use and, where necessary (ie: battery does not retain its
charge), the battery may need replacing (Sections 2e ii) and 5b).
9. WARNING: To avoid the risk of fire or explosion or impaired ventilator
performance, always observe the correct polarity of the auxiliary supply. Ensure
the supply is a stable voltage from 23 to 30 volts capable of supplying 3 Amps (5
Amp surge on motor start) and does not contain excessive interference (Section
2e) iii).
10. WARNING: When in use in a contaminated atmosphere, to avoid the risk of harm
to the patient, the NBC filter must be fitted (Section 2e iv)).