Oce Repro Desk, Руководство пользователя, Страница: 275 / 464

Print on an Océ 9600 275
Adapt the leading edge position of the sheet feeders
If you want to adapt the leading edge position of the sheet feeders, and you
know which value you want to choose, you simply enter this value (in tenths
of millimeters) into the Enter value field and click on the Leading Edge
Position button. After confirmation, the leading edge position is set to the
specified value. If you do not know which value you want to enter you can take
the following procedure.
▼
Adapt the leading edge position of the sheet feeders
1
Make a basic test print from Sheet Feeder 1 by clicking on the Test Print Basic
button on the Other tab.
2
Take a ruler and measure the distance between the edge of the paper and the D
marker on the test print.
3
Enter the resulting value (in tenths of millimeters) in the Enter value field and
click on the Edge and marker “D” button.
The leading edge position is adapted automatically, based on the specified
value.
Note:
If an invalid value is entered, the following message is displayed: ‘Value
x is out of bounds. Range is from a to b. Default is c’, where x is the specified
value, a the minimum value, b the maximum value, and c the default value.
Modify the sheet feeder width positions
If you want to modify the width positions of the upper, middle or lower sheet
feeders, and you know which value you want to choose, you simply enter this
value (in tenths of millimeters) into the Enter value field and click on the
appropriate button. After confirmation, the appropriate width position is set to
the specified value. If you do not know which value you want to enter you can
take the following procedure.
▼
Modify the sheet feeder width positions
1
Make a basic test print from sheet feeder 1 (for the upper drawer), sheet feeder
2 (for the middle drawer) or sheet feeder 3 (for the lower drawer) by clicking
on the ‘Test Print Basic’ button on the ‘Other’ tab.
2
Take a ruler and measure the distance between the edge of the paper and the E
marker on the test print.
3
Enter the resulting value (in tenths of millimeters) in the Enter value field and
click on the appropriate Edge and marker “E” x Sheet Feeder button, where x
can be Upper, Middle or Lower.