Oce CS6407, Основное руководство по эксплуатации

Страница: 53 / 100

53
Introduction
For your basic operation
Maintenance
When encountering a problem
Appendix
4
By pressing the key, feed the media until
the front media edge is wound on the paper
tube.
F E E D I N G M E D I A
5
Tape
Paper
tube
Install the printed media to the paper tube.
(1) Check the take-up direction, remove the slack of the
media, and then make sure that the media is not
deviated on the supply side and the takeup side.
(2) Attach the media to the paper tube with adhesive
tape. Tape it fi rst at the center, and then at the right
and left sides, so that the tension is uniform across
the media width and that no wrinkles are found on
the media. The taped positions are recommended to
be totally three or more.
Inner take-up:
Media is taken up
with its print surface
coming inside.
Outer take-up:
Media is taken up
with its print surface
coming outside.
Points to be noted on winding media
- If the media is not installed straight to the paper tube, a skew of media may occur.
- When the take-up direction is set as Inner take-up, the taken-up
media's diameter increases and the media cannot
backfeed after printing. Select [FWD ONLY] beforehand in MEDIA BACK MODE of MEDIA REG MENU. (When the
media backfeeds in [BACK&FWD] mode, the motor idles and may cause a trouble.)
6
Take-up direction switch
OFF
u
Outer take-up
- OFF
v
Inner take-up
Set the take-up direction switch according to
the take-up direction.
7
By pressing the key feed the media, and
wind one full turn of the media on the paper
tube.
F E E D I N G M E D I A
8
Input the data in the software RIP.