Oce CS6407, Основное руководство по эксплуатации

Страница: 39 / 100

39
Introduction
For your basic operation
Maintenance
When encountering a problem
Appendix
To load media on the take-up reel unit
This section explains the procedure, taking in TENSION winding mode for instance.
1
Load a paper tube onto the scroller fl ange and scroller shaft.
(4) Push the flange shaft fixture as far
as it goes.
Handle
Flange shaft fixture
Flange shaft fixture
Fixture
Move the roll spacer to the paper tube center, and
fasten the fixtures at the roll spacer’s both sides.
Pass the scroller shaft through the roll spacer with fixtures at its
both sides, scroller flange, and flange shaft fixture.
The roll spacer prevents the
paper tube from bending at
the center due to the media
weight.
Flange spacer
Flange spacer
(1) Insert the flange spacer
between the scroller flange and
the paper tube.
(2) Push the scroller flange until it
stops and turn the handle
clockwise until the flange is
fixed to the paper tube.
(3) Remove the flange spacer.
(5) Turn the knob to fix the scroller
shaft.
Check the flange
spacer’s correct position.
The flange spacer should
be inserted to the
position indicated by the
line B.
Be careful not to deform
it by applying too much
force.
A
B
Scroller flange
Flange spacer
Flange shaft fixture
NOTE:
- To wind the media in LOOSE
winding mode, without inserting
the flange spacer, push the scroller
flange as far as it goes.
Scroller flange
Scroller shaft
Roll spacer
Scroller flange
Roll spacer
Paper tube
Flange spacer
Not required in LOOSE
winding mode.
Not required in LOOSE
winding mode.