Oce CS240, Руководство по эксплуатации

Страница: 547 / 594

CS240/CS231 13-55
Utility mode 13
6
Check the horizontal position of the punched holes.
– To increase width A, touch [+] to increase the adjustment (between 0.1 mm and 5.0 mm).
– Each time [+] or [-] is touched, the value is increased or
decreased by one increment.
– To decrease width A, touch [-] to decrease the adjustment
(between -0.1 mm and -5.0 mm).
7
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The horizontal position of the punched holes is adjusted.
If no adjustment of the horizontal position of the punched holes was necessary in step 6, this completes
the procedure.
8
Use a Punch setting to print another sample copy.
9
Check the print result.
– Check that the horizontal position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.
Punch regist loop size adjustment
The angle of punched holes when printing with a Punch setting can be adjusted.
2
Note
For details on the Punch settings, refer to "Punching holes in copies ("Punch" settings)" on page 4-69.
The adjustment range differs depending on the finisher that is installed.
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Setting screen, refer to "Displaying the administrator
settings screen" on page 13-35.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.