Oce CS240, Руководство по эксплуатации

Страница: 517 / 594

CS240/CS231 13-25
Utility mode 13
*1
Appears when finisher FS-608 is installed.
*2
Appears when finisher FS-608 or finisher FS-517 is installed.
*3
Appears when finisher FS-519 is installed with the saddle stitcher attached.
*4
Appears when finisher FS-519 is installed.
Finisher Ad-
justment Punch Regist Loop
Size Adjustment
*4
Adjust the hole-punching shift (between -4 and 4
mm) for double-sided printing and outputting cov-
er pages. 0.0 mm
Density Ad-
justment Thick 1/1+–Yellow Adjust the image density for printing on thick pa-
per or OHP transparencies. The density can be
adjusted separately for each color (yellow, ma-
genta, cyan and black for a color image and the
black image density). The higher the setting, the
darker the density.
Adjust the setting for yellow, magenta, cyan and
black between -5 and +5.
Adjust the setting for "Black Image Density" be-
tween -2 and +2. 0
Thick 2/3/4–Yel-
low 0
Thick 1/1+–Ma-
genta 0
Thick 2/3/4–Ma-
genta 0
Thick 1/1+–Cyan 0
Thick 2/3/4–Cyan 0
Thick 1/1+–Black 0
Thick 2/3/4–Black 0
Black Image Den-
sity 0
Image Stabilization Perform an image stabilization if the image is in-
correct, even after the gradation levels have been
adjusted.
•
Image Stabilization Only:
Perform a normal image stabilization.
• Init Image Stabilization Only:
Select when a good result was not achieved
after "Image Stabilization Mode" was select-
ed.
Image Stabilization Only
Paper Separation Adjustment Adjust the paper position where the two sides are
separated (between -2.0 mm and 2.0 mm) during
double-sided printing. 0.0 mm
Color Regis-
tration Ad-
just Color Registration
Adjust (Yellow) Adjust the color registration if color shifts can be
seen in the print result. -
Color Registration
Adjust (Magenta) -
Color Registration
Adjust (Cyan) -
Gradation
Adjustment Image Stabiliza-
tion Only When adjusting the gradation levels, first press
the [Start] key to perform image stabilization. -
Copy Adjust the gradation levels if there are changes in
the color gradations of the print image. The ad-
justment is made with stress on increasing the
number of images stored in the memory. -
Printer (Gradation) Adjust the gradation levels if there are changes in
the color gradations of the print image. The ad-
justment is made with stress on the gradations in
images. -
Printer (Resolu-
tion) Adjust the gradation levels if there are changes in
the color gradations of the print image. The ad-
justment is made with stress on the reproducibility
of text and lines. -
Line Detec-
tion Prior Detection
Setting Select whether or not a warning appears when the left partition glass is dirty,
and specify the dirt detection level. The dirt detection operation is performed
before and after scanning a document using the ADF.
Detection While
Feeding Setting Specify the level at which dirt is detected when scanning a document using the
ADF. If "Do Not Remove" is selected, the operation to remove lines is not per-
formed.
Trail Edge Adjust Adjust shifting if it can be seen at the trailing edge
of the print result. -
Parameter Description Default Setting