Oce CS 4050, Руководство по установке

Страница: 14 / 51

14 Océ CS 4040/4050 Installation Manual
Note:
You use the COPY-SCSI connector (1) when you run a separate “copy
computer” configuration at the same time as the scan-to-file configuration.
6
Set up the scanner SCSI address.
SCSI address setup
You set the SCSI device number on the DIP switch behind the scanner. The
device number applies to both the SCAN-SCSI bus and the COPY-SCSI bus.
▼
To set up SCSI device address
1
Power off the computer and the scanner.
2
To locate the DIP switch, slide the streamer on the front of the scanner to the
left.
3
Press the “Push” button to slide out the “smart card” holder.
4
Remove the “smart card” to access the switch.
Note:
Remember to replace the “smart card” before you turn on the
scanner.
5
Select an unused SCSI device address number according to the table below.
SCSI device
no.
Switch
1
2 3 4 5 6 7 8
0 ON ON ON - - - - X
1 OFF ON ON - - - - X
•2 ON OFF ON ON OFF OFF OFF X
3 OFF OFF ON - - - - X
4 ON ON OFF - - - - X
5
OFF ON OFF - - - - X
6 ON OFF OFF - - - - X
7 OFF OFF OFF - - - - X
SCSI-0
built-in
termination
- - - ON - - - X
X
SCSI-0
synch.
transfer off
- - - - OFF - - X
SCSI-1
synch.
transfer off
- - - - - OFF - OFF
[4] • Factory default