Oce 3275, Руководство пользователя

Страница: 228 / 340

12-2 Tandem Mode
Tandem Mode
Tandem Mode Operation
Tandem mode enables your 3275 primary (master) copier to work in tandem with the
3275 secondary (sub) copier connected using a cross cable, for the purpose of providing
faster completion of large copying jobs. Two units working in tandem distribute a job in
half the time of non-tandem mode.
NOTE: Service setting is required to use the tandem mode. Contact your service center, if desired.
❒
Two 3275 copiers should be connected using a cross cable.
❒
Two copiers should have the same optional configuration except for the option tray (Large
Capacity Trays).
❒
Two copiers should be turned on and ready for copying.
❒
The copier with the TANDEM key highlighted on the Finisher Mode Selection Screen will be
the primary (master) copier, turning both copiers into the tandem mode.
Select the copying conditions, scan originals, and press [START] on the primary copier to
operate both copiers in tandem to complete a job.
❒
Print quantity must be set for [3] or more copies to activate the tandem mode.
When the print quantity entered is an odd number, the primary copier will copy and output one
sheet/set more than the secondary copier to accommodate the job.
❒
Auto low power/Auto shut-off may function while tandem mode is selected.
• If the tandem mode is selected while the secondary copier is in Auto low power mode, the
power saving mode will be released automatically.
• The tandem mode will not be selected when the secondary copier is turned off by Auto shut-
off. Release the Auto shut-off mode by pressing [POWER SAVER ON/OFF].
• If Auto low power is activated on the secondary copier during the tandem job setting, the
power saving mode will be released automatically when printing job starts.
• If Auto shut-off is activated on the secondary copier during the tandem job setting, the
tandem mode will be released automatically.
• If Auto low power/Auto shut-off is activated on the primary copier, the tandem mode will be
released automatically.
❒
Auto reset may function while tandem mode is selected.
Initially, the tandem mode will be released automatically if Auto reset is activated on the
primary copier.
Key operator can set the primary copier to select the tandem mode as initial setting. Apply this
setting to the primary copier only, if desired. Setting on both copiers will deactivate the tandem
mode.
❒
The 3275 is provided with an Allocation recovery mode, which functions when trouble occurs
in either the primary or secondary copier to allow the trouble-free copier to complete the job.
❒
The copier with ECM setting activated cannot be used for tandem mode copying. Release the
ECM setting of both copiers to use the tandem mode.
❒
Interrupt copying is available only on the copier with [INTERRUPT] pressed.
❒
If the primary copier is installed with HDD, the image data stored in HDD can be output in
tandem mode copying.
❒
Corresponding tray sizes on the primary and secondary copiers should be the same when
using multiple trays for a single job.