40
ANNUAL PREVENTIVE MAINTENANCE INSTRUCTIONS
Optional Clean Sweep® Condensing Coil Cleaner:
Important! Disconnect power from case before cleaning the Clean Sweep® Condenser Coil Cleaner!
•
Remove front grille (by removing 4 screws).
•
Slide/roll out condensing unit assembly.
•
Remove the four (4) screws holding Clean Sweep®
rails intact.
•
Remove the Clean Sweep® rail.
•
Wash rail and brushes in hot water and mild soap solution.
•
If brushes are worn, they must be replaced. Call Technical Service Department to replace. Toll
-
Free
number is listed at end of manual.
•
Caution! Coil fins are sharp. Handle with care!
•
Reattach Clean Sweep® rail to condensing unit (4 screws).
•
Slide/roll condensing unit assembly back under case.
•
Replace front grille to case in same manner it was removed.
•
See photos below.
(4) Screws
---
Above photos are taken after front (or rear) grille has been removed from case
---
Brushes
Rail
PREVENTIVE MAINTENANCE
-
TO BE PERFORMED BY TRAINED SERVICE PROVIDERS ONLY
-
4 of 4
WARNING! TURN OFF CASE BEFORE PERFORMING PREVENTIVE MAINTENANCE!
