Space to think
www.oasis-berco.com
St
e
p
4
A.
Make sure the structure is square and all panels line up with the top posts and
frame headers. Tighten all bolts once all is square.
B.
Install the door side glass panels into position.
Be careful not to set the glass on a
corner or it will chip or break.
i.
Lift the left side glass panel into the top groove and then set down into
the base groove. (Use double handle glass suction cups provided.)
ii.
Repeat for the right side glass panel.
iii.
Push the side glass panels in towards the hinge plates and door stop
where the door glass will be installed (Step 9).
C.
Make sure the frame and glass panels are square. Push the glazing seal (see picture
below) around the top and sides to secure the panels in place. You will need to cut
seal to correct length. This gasket is push in place and will form a tight seal to hold
the glass panel.
Glazing Seal
