Space to think
www.oasis-berco.com
A.
Test the door again to make sure the closing speed is working properly. If the door
needs adjustment, see instructions at the end of this document.
B.
Give the booth a final clean on the all painted profiles, glass & work surface.
C.
Remove the film covering that is protecting the threshold.
D.
Use a lint roller on the fabric panels to remove any handling marks.
E.
Adjust the motion sensor as follows:
i.
Press and hold the button on the side for 5 seconds until the red LED
illuminates. Then press:
a.
Twice for 10 minutes
b.
Three times for 30 minutes
c.
Four times for 60 minutes
ii.
After the countdown timer is set, the LED will flash the same number of times
the button was pressed to confirm the new timer setting.
F.
Secure the motion sensor to the interior top corner by using the double stick tape
provided on the back of the sensor.
G.
Install any optional furniture. Installation instructions are supplied at the end of this
document.
St
e
p
10
