![background image](http://html1.mh-extra.com/html/oasis-berco/oasis-linear-duo/oasis-linear-duo_safety-and-installation-instructions-manual_3118810007.webp)
Space to think
www.oasis-berco.com
St
e
p
5
A.
Install the rear glass panels.
Be careful not to set the glass on a corner or it will
chip or break.
i.
You can install from either inside or outside the Pod.
ii.
Lift one panel into the top groove and slide down into bottom groove.
iii.
Clean the edge of the glass facing the center of the Pod.
iv.
Install the “I” gasket (see picture below) by removing the adhesive strip
from one side and attaching it to the glass.
v.
Lift the second panel into the top groove and slide down into the bottom
groove.
vi.
Clean the edge of the glass facing the center of the Pod with alcohol wipe.
vii.
Remove the adhesive strip from the “I” gasket and press the two pieces of
glass together.
B.
Center the combined glass panels in the opening.
C.
Push the glazing seal (see picture below) around the top, and sides to secure the
panels in place. You will need to cut seal to correct length. This gasket is push in
place and will form a tight seal to hold the glass panel. It should be installed on the
inside of the Pod.
Glazing Seal
“I” Gasket