Oase OptiMax 2000, Руководство по эксплуатации

Страница: 9 / 20

- EN -
14 OptiMax 2000/3000/4000/5000
Possible consequences: The pump will be
destroyed.
Protective measure: Regularly check the
water level in the aquarium.

A
•
Fit the supplied suction cups with a twisting
movement.
–
The suction cups adhere to clean, smooth
surfaces.
Submerged installation of the pump

B, C
•
Fit the hose connector as required and con-
nect to a suitable hose. ( → Technical data)
•
Adjust the flow at the flow regulator.
– To reduce the flow: Move the flow regula-
tor in the direction - .
–
To increase the flow: Move the flow regu-
lator in the direction + .
•
Install the device in the aquarium.
Dry installation
N O T E
The pump is not self-priming and must
be installed below the level of the water.
How to proceed:

D
•
Pull off the filter housing.
•
Fit the hose connector as required and con-
nect to a suitable hose. ( → Technical data)
•
Adjust the flow at the flow regulator.
– To reduce the flow: Move the flow regula-
tor in the direction - .
–
To increase the flow: Move the flow regu-
lator in the direction + .
•
Install the device outside of the aquarium.
COMMISSIONING/START-UP

C
•
Route the power connection cable such that
it forms a drip loop!
•
Switching on: Connect the unit to the mains.
The unit switches on immediately.
•
Switching off: Disconnect the unit from the
mains.
MAINTENANCE AND CLEANING
If necessary, clean the unit with clear water using
a soft brush.
•
Do not use cleaning agents or chemical solu-
tions. We recommend using OASE PumpClean
for removing calcium deposits.
Replacing the impeller unit

E
How to proceed: