1085231-2-A
Page 1 of 3
P23010
Floor Riser Support Assembly
THANK YOU FOR CHOOSING KALLISTA
BEFORE YOU BEGIN
TOOLS AND MATERIALS
1. ASSEMBLE THE PIPE HOLDERS & TEE BRACKET
We appreciate your commitment to Kallista quality products. Please take a moment to review this manual before
you install your Kallista product. If you encounter any installation or performance problems, please do not
hesitate to contact us at the phone number listed at the bottom of the page.
Prior to installation, unpack the floor riser support assembly and inspect it for damage. If the product is
damaged, please contact Kallista immediately at the phone number listed at the bottom of the page.
Shut off the main water supply.
Observe all local plumbing and building codes.
The installation of the riser support assembly should coincide with the installation of the floor risers.
To prevent damaging the tub, the floor riser support assembly should be mounted a minimum of 12” from the
floor.
Kallista reserves the right to make revisions in the design of plumbing products without notice, as specified in
the Price Book.
Silicone
Hex
Wrench
Pencil
Drill
Hacksaw
Pipe Holder
Pipe Holder
Tee Bracket
Thread the pipe holders onto the tee bracket.
Use the hex wrench to back the set screws out slightly,
so that the floor risers (not provided) can be inserted
without scratching them.
Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INSTALLATION INSTRUCTIONS
Phillips
Screwdrivers
Strap
Wrench
Tape Measure
or Ruler
Set Screw
