Oase OptiMax 2000, Руководство по эксплуатации

Страница: 10 / 20

- EN -
15
1. Loosen and remove the screws at the side of
the pump lid.
2. Remove the pump lid.
3. Remove the impeller unit.
– If necessary, use a wide-blade screwdriver
to lever the impeller unit out of its posi-
tion in the motor housing. For this, insert
the screwdriver blade into the groove be-
tween the impeller unit and motor hous-
ing, and firmly turn the screwdriver in or-
der to dislodge the impeller from its posi-
tion.
– Proceed carefully so as not to damage the
motor housing or O ring.
4. Clean or replace the impeller unit and subse-
quently reassemble the pump in the reverse
order.
–
OptiMax 4000/5000: Firmly push the im-
peller unit into position in the motor
housing.
REMEDY OF FAULTS
Malfunction Cause Remedy
The unit does not start up No mains voltage Check the mains voltage.
Impeller unit blocked Clean
Water flow insufficient Position of the flow regulator Readjust the flow regulator.
Filter housing or impeller unit
soiled, hose blocked
Clean
Hose defective Replace
Hose kinked Route hose in a straight line
Impeller unit worn Replace impeller unit
Only submersed during installa-
tion
Filter housing clogged Clean the filter housing.
WEAR PARTS
The following components are wear parts and
are excluded from the warranty:
•
Suction cups, impeller unit
REPAIR
A damaged unit cannot be repaired and must be
put out of operation. Dispose of the unit in ac-
cordance with the regulations.