Oase FiltoSmart 100, Руководство по эксплуатации

Страница: 14 / 32

‐
EN
‐
14 FiltoSmart 100/200/300
Connecting the hose
The procedure is identical for the inlet (IN) and outlet
(OUT).
How to proceed:

K
1. Shorten the hose to the required length.
–
Chose the length so that the hose cannot kink in
the intended installation position.
2. Screw the union nut onto the hose connector of the
connection unit.
3. Push the hose onto the hose connector and turn the
union nut counter ‐ clockwise to fix the hose in place.
4. Push the other end of the hose onto the hose con ‐
nector at the suction unit/flow ‐ out unit and turn the
union nut counter ‐ clockwise to fix the hose in place.

C

Fasten the suction unit and flow ‐ out unit in the
aquarium using suction cups.
COMMISSIONING/START
‐
UP
N O T E
Thoroughly rinse out all filter material with warm tap
water before using for the first time in order to remove
any soiling. ( → Cleaning/replacing the filter media)
N O T E
Ensure that the pump never runs dry!
The pump will be destroyed.

Regularly check the water level and circulation in
the filter and in the aquarium.
How to proceed:

N
•
Completely fill the container with water and place it
next to the aquarium.
–
Fill the container via the opening. For this, remove
the blind plug.
–
When starting it up for the first time, ensure that
the connection unit is max. 80 cm below the sur ‐
face of the water. Ensure that the water outlet
(flow ‐ out pipe or water distributor) is not sub ‐
merged.
–
A completely filled filter may be more than 80 cm
below the surface of the water. Note the maxi ‐
mum head height. ( → Technical data)
•
Route each power connection cable such that it
forms a drip loop.
Switching on:
Connect the unit to the mains. The unit
switches on immediately. When the unit is switched
on, it takes several minutes for the air to escape from
the unit (this makes a noise).

Adjust the flow at the flow regulator if necessary.
( → Assembling the suction unit)
Switching off:
Disconnect the unit from the mains.
TROUBLESHOOTING
Malfunction Cause Remedy
Unit does not start up. No mains voltage Check the mains voltage.
Impeller unit blocked Clean
Excessive height difference between the top edge of
the aquarium and the suction unit
Reduce the height difference
Water level in the unit too low Top up water
Water flow insufficient Filter housing or impeller unit soiled Clean
Impeller unit worn Replace the impeller unit.
Flow incorrectly set Correct the setting
Foam filter soiled Clean
Activated carbon soiled Clean
Ceramic substrate soiled Clean
Suction basket clogged Clean suction basket.
Pipework soiled Clean suction unit, flow ‐ out unit and
hoses.
Insufficient filtering performance Foam filter soiled Clean
Foam filter worn Replace
Ceramic substrate soiled Clean
Ceramic substrate worn Replace
Activated carbon exhausted Replace
Increased noise Air in the filter, vent hose on the pump not correctly
positioned.
Correct the position of the vent
hose.