D
3250
Using the Controller Display
D3250 Main Menu
Raise
Lower
Select
Alarm
Parameters
Time Clocks
Timers
Drive Settings
Motor Settings
The barriers PLC has a remote controller display screen where you
Can change features and operate the barrier. The Installer should
Have the screen or it should be left in the barrier control cabinet.
The Remote display should be plugged into the serial port 1 on the
PLC to enable it to operate the Barrier.
To operate the display you simply use the dial/arrows to navigate
Your way through the screen. There is an ESC key which will take
You back to the home screen if you want to return.
Home
Select
Alarm
Controller Setup
Operator Interface
The home screen is always the first
Screen that appears after the gate is
Powered up. You will only ever need
To access operator interface to
Operate and change parameters
Of the barrier.
Once you select operator interface
You will see the screen shown in
The left diagram which shows
Settings you can alter. One very
Useful feature is the R4 and R3
Key can raise and lower the barrier
As shown in the bottom right hand
Of the screen.
D3250 Main Menu
Select
Alarm
Parameters
Time Clocks
Timers
Drive Settings
Motor Settings
Using the Arrows/dial navigate the
Cursor to operator interface and
Press ok and you will see the
Parameters menu. Press OK with
The cursor on parameters and all
The parameters will then appear.
Parameters
ON
OFF
Alarm
Safety Reverse ON
You
can
now
scroll
through
the
Parameters and choose what you would
Like to turn on. To turn on/off use the
R1/R2 key which is labelled on the screen
in the bottom left corner.
The barriers PLC has various parameters that can be set so you can
Alter the way the barrier operates.
To change the parameters you will need access to the PLC graphic
Display, once you have access to this Follow the below instructions.
No Pass Timer OFF
Loop/Photocell Close ON
Boom Lights OFF
Flashing Boom Lights OFF
D
3250
Setting the barriers parameters
Raise
Lower
