15
DIReCTIONS fOR USe
DIR
e
CTIONS
f
OR
US
e
1.
Fill the unit with water at the desired temperature approximately 2” above the jet cover.
You can fill your sink with:
a. The optional plumbed faucet (if supplied).
b. The supplied fill hose with connector - to attach to a typical sink spout.
2.
To activate or deactivate this appliance, turn the ON/OFF button to “ON”.
3.
Bath additives (including oil based products) can be used in this foot bath, since
their residue can be easily cleaned. CAUTION: Use only low foaming additives.
4.
You should always be in a seated position when putting your feet in or removing
them from the foot bath. WARNING: NEVER STAND IN THE FOOT BATH.
be sure to read all
cautions, warnings
and instructions given
in the manual to
prevent injury to both
operator and client.
dIrectIons for use
openIng/closIng the foot sectIon
place this end
in foot bath
attach this end to
your sink spout
supplied fill hose
To open fooT secTion
1.
Standing at the side of the table, with both hands, gently lift the moveable leg rest
slightly and pull outward until it stops.
2.
Lower leg rest until it stops in a vertical position aside the foot bath
3.
Repeat steps 1 & 2 for the other side of the table.
warnIng
Do not sit on moveable leg rest.
Max weight limit 125 lbs (57 kg)
To close fooT secTion
1.
Standing at the side of the table, lift the lowest part of the movable leg rest up
with both hands & push towards the center of the table.
2.
Repeat for the other side of the foot section.
3.
Both foot sections will drop into a small “detent” in the slide section to make sure
the foot section does not open during the client treatment.
NOTE
: If the foot section is opening during treatment, it is likely that the two
sections are not closing fully. Check to be sure there is a gap between the pads
when two sections are put together. If the pads are too tight, remove the pads,
move outward slightly and reattach. (The pads are held on with Velcro
®
. Pull hard
and they will come off.)
foot bath
