O.S. engine MAX FXi 46, Инструкция пользователя

Страница: 9 / 28

throttle stick is fully retarded.
Adjustment of the throttle rotor opening
at the idling position can then be made
with the throttle trim lever on the
transmitter. (Select throttle-lever and
servo-horn hole positions that will
avoid excessive pushrod travel causing
the throttle to bind at either end.)
Note: When adjusting the throttle lever
angle, relative to the rotor, hold the rotor
at about half-way between the open and
closed positions while loosening and
tightening the fixing screw, otherwise
the rotor, rotor guide screw, throttle stop
screw or carburetor body may become
burred and damaged.
The exhaust outlet of the silencer can be
rotated to any desired position in the
following manner:
1)
Loosen the locknut and assembly screw.
2) Set the exhaust outlet at the required
position by rotating the rear part of
the silencer.
3) Re-tighten the assembly screw,
followed by the locknut.
Note: The standard expansion-chamber
type silencer is quite effective, but
reduces power to some degree.
Reminder: Model engines generate
considerable heat. Do not touch any part of
your engine until it has cooled. Contact with
the muffler (silencer), cylinder head or
exhaust header pipe, in particular, may
result in a serious burn.
Keep your hands and face away from
exhaust gas or you will suffer a burn.
Suggested fuel tank capacities are listed
opposite. These will allow 12-13 minute flights.
Locate the fuel tank so that the top of the
FUEL TANK LOCATION
MUFFLER
9