Table 4. LPC55S36-EVK features (continued)
Board feature
Target MCU feature used
Description
I3C
I3C module (I3C0)
I3C slave devices:
• 6-axis motion tracking device with integrated 3-axis
gyroscope and 3-axis accelerometer
• One of the connectors of the Motor 1 + unused MCU pin
socket
Octal flash
FlexSPI host controller
512 Mbit octal serial NOR flash memory
DMIC
Digital PDM microphone (DMIC)
module
Onboard DMIC and an external DMIC connector
mikroBUS
mikroBUS socket with two 1x8 position receptacles
Motor control and
Arduino
Motor control subsystem (FlexPWM0,
FlexPWM1, ADC0, ADC1, DAC0,
and DAC1)
Two Arduino UNO compatible sockets, each with four
receptacles (2x6, 2x8, 2x10, and 2x8 positions)
Power supply
The board accepts the following external power supplies:
• External 5 V power through one of the three USB
connectors
• VIN1 power from one of the connectors of the Motor 1 +
unused MCU pin socket
• VIN2 power from one of the connectors of Motor 2 +
Arduino socket
Clock
Two crystals (16 MHz and 32.768 kHz) provide clocks to the
target MCU
Debug
• MCU-Link debug probe (onboard debug probe) can be
used to debug the target MCU using a USB micro-B
connector provided on the board. It supports CMSIS-
DAP and SEGGER J-Link protocol options.
• An external debug probe can also be attached for
debugging the target MCU
• MCU-Link debug probe can also be used for debugging
an external target MCU
1.6 Board pictures
The figure below shows the top-side view of the LPC55S36-EVK board, with connectors, push buttons, and LEDs highlighted.
NXP Semiconductors
LPC55S36-EVK Overview
LPC55S36-EVK Board User Manual, Rev. 1, 24 January 2022
User Manual
8 / 49