Table 23. LPC55S36-EVK GPIOs (continued)
Target MCU pin
Board devices where GPIO function is used
GPIO mode control
PIO1_8
Motor 2 c Arduino socket (pin 10 of connector J122)
To enable GPIO mode, set
configuration resistor R523 in
position B (2-3 shorted)
PIO1_25
Motor 2 c Arduino socket (pin 12 of connector J122)
GPIO mode is enabled by
default (pins 1-2 of jumper JP52
are shorted)
PIO1_0
Motor 2 c Arduino socket (pin 14 of connector J122)
Only for GPIO function
PIO1_28
Motor 2 c Arduino socket (pin 16 of connector J122)
Only for GPIO function
The onboard audio codec is the only interrupt source on the LPC55S36-EVK board. Interrupt triggered by audio codec is received
at the target MCU GPIO pin PIO1_13.
2.15 Board errata
No board errata.
2.16 Board operating conditions
The LPC55S36-EVK board should be used in laboratory conditions (0 ℃ to 50 ℃). It is not intended for extended temperature
testing. See LPC5536 Data Sheet for complete details on device operating conditions.
NXP Semiconductors
LPC55S36-EVK Functional Description
LPC55S36-EVK Board User Manual, Rev. 1, 24 January 2022
User Manual
41 / 49