NXP Semiconductors
KTFRDMHB2001FEVMUG
FRDM-HB2001FEVM evaluation board
KTFRDMHB2001FEVMUG
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2016. All rights reserved
User guide
Rev. 1.0 — 25 May 2016
20 / 35
FRDM-KL25Z Board
FRDM-HB2001FEVM
Brushed DC Motor
5 - 40 V Power Supply, 20 A
Workstation
Standard A to Mini-B
USB Cable
USB
Figure 13. FRDM-HB2001FEVM configured for use with an FRDM-KL25Z board
6.1.2 Step-by-step instructions for setting up the hardware for use with a
function generator
This section describes how to configure the FRDM-HB2001FEVM for use with a function
generator. The same connections apply if the board is connected to a microcontroller
instead of a function generator. See the board description (
Section 4.4 "Board
description"
), the schematic (
Section 7 "Schematic"
) and the MC33HB2001 datasheet, to
configure the board for use in a specific environment.
1. Connect the function generator to the EX_IN jumper, with one channel attached to
each pin.
2. Change the board jumper connections, as shown in
Figure 14
.
3. With the power switched off, attach the DC power supply to the VBAT and GND screw
connector terminal (J20) on the evaluation board.
4. Connect the load to the screw terminal (J21).
Figure 14
illustrates the hardware configuration.