NXP Semiconductors FRDM-HB2001-EVM, Руководство пользователя, Страница: 19 / 31

Installing the software and setting up the hardware
FRDM-HB2001-EVM evaluation board , Rev. 1.0
NXP Semiconductors 19
5.1.2 Step-by-step instructions for setting up the hardware for use with a function
generator
This section describes how to configure the FRDM-HB2001-EVM for use with a function generator. The same connections apply if the
board is connected to a microcontroller instead of a function generator. See the board description ( Section 3.4, Board description, page
8 ), the schematic ( Section 6, Schematic, page 25 ) and the MC33HB2001 datasheet, to configure the board for use in a specific
environment.
1. Connect the function generator to the EX_IN jumper, with one channel attached to each pin.
2. Change the board jumper connections, as shown in Figure 15 .
3. With the power switched off, attach the DC power supply to the VBAT and GND screw connector terminal (J20) on the
evaluation board.
4. Connect the load to the screw terminal (J21).
Figure 15 illustrates the hardware configuration.
Figure 15. FRDM-HB2001-EVM configured for use with a function generator
Brushed DC Motor
Function Generator (or MCU)
5 - 40 V Power Supply, 20 A
VDD jumper
remains in
1 - 2 (default)
position
Jumpers moved from
1 - 2 (default) to
2 - 3 position
Jumpers moved from
1 - 2 (default) to
2 - 3 position